Often asked: Radio Code For 2002 Acura Tl?

How do I get the radio code for my 2002 Acura TL?

You can retrieve your code by visiting https://radio-navicode.acura.com/. You’ll need your vehicle identification number (VIN) and Device Serial Number in order to retrieve the code through the website.

How do I get the radio code for my Acura TL?

How to Enter Acura Radio Codes

  1. Obtain the radio code for your car. Honestly, finding the radio code for your Acura is usually the most challenging step of them all.
  2. Press the power button until CODE displays. Once CODE is shown on the radio display, you can enter the code in.
  3. Type in the code.

How do I reset my Acura TL radio?

Device Display

  1. Turn the ignition switch to ON.
  2. Turn ON the device and confirm that the display reads CODE.
  3. Turn OFF the device.
  4. Press and hold the 1 and 6 radio preset buttons and turn ON the device.
  5. The first screen displays a U and the first four digits of the serial number (for example, U2200).
You might be interested:  Quick Answer: Aston Martin Db9 Red?

What is Acura radio code?

Step inside the cabin of your Acura vehicle and turn the vehicle on. The radio should still say “CODE” — that simply means the security system kicked on because it lost power from your battery.

How do I unlock my radio?

With the Unlock Code

  1. Locate the anti-theft/unlock code. Most cars have a special anti-theft radio card that is included with the owners manual packet containing the unlock code and serial number.
  2. Turn the car’s ignition switch to the “on” position. This turns on your car’s electrical system and powers up the radio.

How do I unlock my car radio?

Contact a local car radio installation center

  1. To bypass radio security codes on these vehicles, switch on your ignition to the ON position.
  2. Turn on your audio system and see if it displays CODE.
  3. Then, you want to press and hold down the radio power button.
  4. You have to hold it for about 40-50 minutes.

What is the radio code for 2006 Acura TL?

Radio CODE retrieval Instructions: How to get the radio CODE. 2 Push the #1 and #6 buttons on the radio and hold them while turning the radio power on. 3 The screen should give you the U and four digit number than L and four digit number wright that down that’s your serial number.

Where can I find my radio code?

The best place to locate a radio code is in the owner’s manual of your car. In most cases, the owner’s manual will be located in your glove box and will include general automotive service and maintenance tips, along with instructions on how to operate each system on the vehicle.

You might be interested:  Chrysler Electronic Ignition Module?

How do I turn off anti-theft on my Acura TL?

Leave the key and the dashboard lit for at least 8 minutes. This should make the antitheft signal, that has been displayed on your dashboard, disappear. If it does, turn off the ignition and let the car rest for a while. It’s a way to “reset” the system.

Why does my Acura radio says error?

tl: My acura is error e what do I do to fix this



This error code is an indicator that a wrong code was entered too many times in the radio. If you have the correct code you will need to disconnect the negative battery cable for a few seconds and then re enter the code.

How do you reset the service code on a Acura?

Acura MDX: How to Reset the Service Light

  1. Step 1 – Turn car on and access display signals. Turn the car on, but not all the way; that is, don’t turn the engine on.
  2. Step 2 – Access the display signals. Press and hold down on the select/reset button for 10 seconds (or more).
  3. Step 3 – Reset service light and display signals.

Leave a Reply

Your email address will not be published. Required fields are marked *