99 Acura Tl Transmission Fluid?

How do you put transmission fluid in a 1999 Acura TL?

Add Transmission Fluid: 1999-2003 Acura TL

  1. Getting Started – Prepare for the repair.
  2. Open the Hood – How to pop the hood and prop it open.
  3. Remove Dipstick – Access point for transmission fluid.
  4. Add Fluid – Determine correct fluid type and add fluid.
  5. Replace Dipstick – Put the dipstick / cap back in place.
  6. More Info. – Additional information on adding trans. fluid.

What kind of transmission fluid does a 2000 Acura TL take?

Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.

How do you check the transmission fluid on a 1999 Acura TL?

How to Check Your Transmission Fluid

  1. Turn your Acura on. You’ll want your engine warmed up, so you can best check the levels.
  2. Locate the transmission fluid dipstick.
  3. Remove the dipstick and touch the fluid.
  4. Get a rag and wipe off the dipstick.
  5. Use a funnel to bring the level up to full.
You might be interested:  Question: 2002 Acura Mdx Navigation Code?

How do you put transmission fluid in a Acura TL?

Use a funnel to slowly add the transmission fluid into the dipstick tube. Periodically check the level on the dipstick and continue to add until the fluid level reaches the required level. Approximately 1 pt. of transmission fluild will raise the fluid level one notch level.

Does Acura recommend transmission flush?

Still, most owner’s manuals will recommend changing the transmission fluid every 90,000 miles or so. Flushing your transmission’s fluid has fallen out of vogue in recent years because the high-pressure cleaning involved may dislodge debris inside the transmission that can literally gum up the works.

How do you know when to change your transmission fluid?

Things such as trouble going into gear, hard shifts or thumps between gears, slipping or jumping gears, delay in acceleration, and strange noises such as whining or grinding are all signs it’s time to change the transmission fluid.

Is Honda and Acura transmission fluid the same?

Although each have their own part number, both fluids under the two part numbers above are the same. This means that you can use the Honda fluid in an Acura or the Acura fluid in a Honda car.

How much is a transmission for a 1999 Acura TL?

1999 Acura TL Transmission & Drivetrain products start for as little as $2.20!

What kind of transmission fluid does a 2006 Acura TL take?

Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.

How do I check the transmission fluid in my Acura?

How to Check Your Transmission Fluid

  1. Turn on your car.
  2. Find the transmission fluid dipstick.
  3. Remove the dipstick and touch the fluid, moving it around between your thumb and forefinger.
  4. Wipe off the dipstick with a rag, then place it back in the vehicle.
  5. Use a funnel to bring the fluid level up to full, but don’t overfill it.
You might be interested:  Often asked: Audi C Class?

How do you put transmission fluid in a 2009 Acura TL?

Always remember to check your fluids with your ENGINE OFF! Always use genuine Acura Automatic Transmission Fluid.



  1. Step 1 – Remove the plastic undertray.
  2. Step 2 – Loosen the ATF fill cap.
  3. Step 3 – Drain the ATF fluid.
  4. Step 4 – Refill the transmission with fluid.
  5. Step 5 – Check the level.
  6. Step 6 – The 3 x 3 flush.

What kind of transmission fluid does a 2005 Acura TL take?

Lubegard Synthetic Synthetic Transmission Fluid Dexron VI 1 Quart.

Should I change my transmission fluid?

The manufacturer’s maintenance schedule for many automatic transmissions doesn’t call for fresh fluid until 100,000 miles or, with some Ford transmissions, even 150,000 miles. A lot of mechanics say that is too long and that it should be done at least every 50,000 miles.

Leave a Reply

Your email address will not be published. Required fields are marked *